The use of disk gum must have tools, the first to have molding machine, molding machine should have heating plate up and down, open mold time, to make a mold frame, the disk glue in the mold frame, put a few pieces up and down, the middle of the product to open the mold into, and then the closing mode, after the mold up and down heating pressure will be cured, Molding machine temperature is generally set at 180 degrees, the time required Če želite odpreti kalup vsaj 30 minut, splošni tlačni tlak vsaj 30 ton.
Ko kupec ne uporablja časa lepila na disku, se lahko pojavi pojav, ki se ne strdi, to je zato, ker je visokotemperaturni silikagel (disk gumi) pod pogojem ogrevalnega tlaka, zato se lahko strdi, zato se bo, če se bo pojavil le ogrevanje, pol trden pojav.